The energy meter is used to measure the output of a PV Inverter, to display the data on the Color Control GX and the VRM Portal.
This device will automatically isolate your 12V battery when its voltage gets low to protect it from further discharge - but with enough charge left to allow the vehicle to get going again when you return.
Lynx Shunt VE.Can is a 1000A smart shunt with a safety seat, and the built-in battery monitor accurately monitors your battery's charge status.
A DC (DC) modular busbar used to connect batteries to the Lynx DC (DC) distribution system.
A modular DC busbar (DC) with slots for four DC fuses. It will monitor the status of each fuse and indicate its status via the front LED.
Unique ergonomic and aesthetic design of the button
MK2.2 and MK3 provide a galvanically isolated connection to VE.Bus and translate the VE.Bus protocol into "MK2 / MK3 Protocol".
It connects the Victron VE Bus port to a USB connection that you can connect to your computer. Each Phoenix Multi / MultiPlus is ready to communicate with a computer through its RS-485 data port.
The AC current sensor, single phase - max 40A, is a simple external current sensor, used to measure alternating current, power (VA) and to calculate the energy of a PV inverter connected to the AC input or output a Multi or Quattro.
The CANUSB interface is used to connect a VE.Can product to a computer.
EM24 energy meters can be used to monitor three-phase current.
The Digital Multi Control is used to remotely view and adjust AC input currents, and turn on and off the Multi or Quattro.
This panel is intended both for Multis and Quattros.
On-off switch control panel for Skylla-TG charger.